ICARELIFE · Surfaces, Fixtures & Finishes

Medical Cold-Storage Cabinets for Operating Rooms

Active refrigeration built into the operating-room wall, holding temperature-sensitive medicines and preparations between 2°C and 5°C.

A 304 stainless-steel frame and body, tempered-glass viewing window, microcomputer temperature control and alarm functions for high and low temperature, power failure and sensor fault.

304 stainless-steel build Embedded wall installation 2–5°C adjustable

View capacities →

Temperature range2–5°C adjustable

Control accuracy0.1°C

Capacities90 L / 130 L

RefrigerantR600a

Product range

Medical Cold-Storage Cabinets

Two capacities are available, 90 L and 130 L, sharing the same 304 stainless-steel construction, glass viewing window and microcomputer control. Both are designed for embedded installation in the operating-room wall.

Medical cold-storage cabinet with stainless-steel frame and glass viewing window — `MRC-SS-01`**Medical Cold-Storage Cabinet · 90 L**Cold storage · 304 stainless steelW600 × H1000 × D495 mmEmbedded cold-storage cabinet with a 304 stainless-steel frame and body, tempered-glass viewing window, microcomputer temperature control and alarm functions.

Larger capacity medical cold-storage cabinet with stainless-steel frame — `MRC-SS-02`**Medical Cold-Storage Cabinet · 130 L**Cold storage · 304 stainless steelW650 × H1000 × D575 mmThe larger of the two capacities, sharing the same construction, control accuracy and alarm functions for theatres with higher storage volume.

Construction & specifications

Cooling performance you can read at a glance

Temperature is adjustable between 2°C and 5°C with 0.1°C control accuracy, using R600a refrigerant. An LCD touch controller sits flush in the door, and the cabinet raises an alarm for high temperature, low temperature, power failure and sensor fault.

Specification	Detail
Frame & body	304 stainless-steel door frame and cabinet body
Viewing window	Tempered-glass window in the door
Capacity & size	90 L: 600 × 1000 × 495 mm · 130 L: 650 × 1000 × 575 mm
Alarms	High and low temperature, power failure, sensor fault

Project coordination: Contents and setpoint must be approved under your hospital's own protocol. This cabinet is intended for medicines, preparations and selected clinical materials as defined by that protocol — it is not a substitute for dedicated blood-bank or pharmacy refrigeration equipment unless your facility has approved it for that use.

How to specify

How to specify your cold-storage cabinet

Capacity90 L or 130 L, set by what has to be stored

SetpointPoint within the 2–5°C range required by your protocol

InstallationEmbedded into the wall, with ventilation and service access confirmed

ContentsMedicines, preparations and clinical materials as listed in your protocol

MonitoringController readout, plus any external monitoring the facility uses

PowerSupply available at the position, and behaviour on power failure

FAQ

Frequently asked questions

Can this cabinet store blood or blood products?

Only if your facility has approved it for that use. The 2–5°C range suits temperature-sensitive medicines and preparations, but blood products normally fall under blood-bank equipment with its own validation, monitoring and traceability requirements. Confirm against your transfusion service's protocol before specifying.

What happens if the power fails?

The cabinet raises a power-failure alarm so the condition is noticed rather than discovered later. Where continuous monitoring matters, connect it to your facility's alarm or building management system and define the escalation procedure in your protocol.

Is the cabinet free-standing or built into the wall?

Embedded. The cabinet is designed for installation into the operating-room wall so the door sits flush with the finish, which matters both for cleanability and for keeping the corridor clear. Confirm wall thickness and service access before ordering.